How to Set Up a Tattoo Station, Step by Step

Short answer
How do you set up a tattoo station?
Set up a tattoo station in this order: wash hands, disinfect the work surfaces with an EPA-registered disinfectant, glove up, cover every touch point with barrier film, bag the machine and cord, lay a clean drape, then set out single-use ink caps, a rinse cup, ointment and towels. Open sterile cartridges last. Break down by discarding sharps and barriers, then disinfecting everything again.
Key takeaways
- Work from clean to dirty: disinfect first, barrier second, consumables third, sterile items last.
- If gloved hands will touch it during the tattoo, it needs a barrier or must be disinfected afterwards.
- Ink, ointment and stencil solution are dispensed as single-customer portions; nothing goes back into a bottle.
- Florida's tattooing rule requires barrier covers or disinfection of the machine, new gloves per session, single-use ink cups and a USEPA-registered tuberculocidal disinfectant after each procedure.
On this page 6 sections
A tattoo station setup is a routine you will repeat thousands of times, and its whole purpose is to stop blood and ink from one client reaching the next. The order matters more than the products: if you set up in the wrong sequence, you contaminate the barriers you just laid.
This guide is published by Miami Tattoo Supplies, a tattoo supply store in Hollywood, Florida, whose medical and barrier supplies cover most of this list. It describes a standard setup; your shop's procedures and your local health rules come first.
Before you start: what the rules require
Your state or county health rules set the minimum, so know them before you build a routine. In Florida, Chapter 64E-28 of the Florida Administrative Code requires, among other things, that the artist confirm the skin to be tattooed is visibly healthy and wash hands with liquid soap and single-use paper towels before setup; use barrier covers on instruments and equipment that may touch the artist or client, or disinfect the machine afterwards; wear new disposable examination gloves for each session; dispense ink into clean single-use cups for each customer; and disinfect the machine and work area after the procedure with a tuberculocidal disinfectant registered with the USEPA. Other states have their own rules, so confirm yours with the local health department.
Step-by-step setup
Work from clean to dirty, and from the surfaces outwards to the sterile items.
- Wash your hands with liquid soap and dry them with single-use paper towels.
- Disinfect the surfaces. Wipe the tray, armrest, chair, lamp handle and anything else in the work zone with an EPA-registered disinfectant, and leave it wet for the contact time on the label. At the time of writing (November 2026), Miami Tattoo Supplies lists CaviCide Surface Disinfectant Wipes, 160 count, at $19.90.
- Glove up with a fresh pair of disposable gloves.
- Lay barrier film on touch points: lamp handle, power supply buttons, tray edges, chair adjusters, spray bottle triggers, tablet screens. The test is simple: if your gloved hand might touch it during the tattoo, cover it.
- Cover the armrest or chair with a drape sheet or table paper and cover the tray with a dental bib.
- Bag the machine and cord. Slide the machine into a machine bag or pen cover and sleeve the clip cord. A roll such as the Saferly cut-to-length clip cord sleeves and machine bags, listed at $23.90, covers both.
- Bag bottles that will be handled during the session, such as the green soap or rinse bottle.
- Set out consumables: ink caps in a holder, a rinse cup, paper towels, and a single portion of ointment on a clean surface or in a cup.
- Pour ink into the caps from the bottle without touching the cap; nothing returns to the bottle.
- Open sterile cartridges last, once the client is seated and the stencil is on, so the packaging is opened in front of them.
Keep a sharps container within reach before you start, not across the room.
What you need on the tray
A typical tray holds the same items every time, which makes it easy to spot something missing.
| Item | Purpose | Example at MTS (Nov 2026) |
|---|---|---|
| Barrier film | Covers touch points | Medical Barrier Film 4 x 6 roll, $19.90 |
| Dental bib | Covers the tray | Dynarex Patient Dental Bibs black, from $15.95 |
| Ink caps | Single-use ink portions | Ink Caps #16 Large, from $6.50 |
| Rinse cup | Rinsing between colors | Hive Cups rinse cups with cartridge holder lids, from $12 |
| Machine bag or pen cover | Covers the machine | Tattoo Pen Rotary Covers 200 pcs, from $8.75 |
| Gloves | New pair each session | Safe-Touch black nitrile, $14.99 per 100 |
Our guides to barrier protection and ink caps go into each item in more detail, and the gloves and sleeves range at Miami Tattoo Supplies covers the glove and cover side of this list.
Breakdown: the step people rush
Breakdown is where cross-contamination usually happens, because the session is over and attention drops. Do it in a fixed order, with gloves on.
- Remove cartridges from the machine and drop them straight into the sharps container. Do not recap or bend needles.
- Discard ink caps, rinse cups and used towels into the appropriate waste. Unused ink in caps is thrown away, never poured back.
- Strip barriers from the machine, cord, bottles and touch points, rolling them inwards so the contaminated side stays inside.
- Remove your gloves and wash your hands.
- Re-glove and disinfect the machine, cord, tray, armrest, chair and every surface that was in the work zone, observing the label contact time.
- Remove gloves and wash hands again.
Contaminated sharps and blood-soaked waste are regulated. In Florida, a tattoo establishment needs a biomedical waste permit to be licensed. Our guide to sharps disposal for tattoo artists covers containers and collection, and the disinfectants guide explains contact times and what tuberculocidal means.
Practicing the routine
If you are still learning, practice the full setup and breakdown on every practice-skin session, timed. A clean routine should feel automatic before you work on clients. Our studio hygiene supplies guide has the complete consumables list.
Watch
Gear mentioned
Products from the Miami Tattoo Supplies catalog, the publisher of this site. Check current price and stock on the store.

Dynarex
Medical Barrier Film 4 x 6 Roll
View at Miami Tattoo Supplies: Medical Barrier Film 4 x 6 Roll
Saferly
Clip Cord Sleeves + Machine Bags - Cut-to-Length Roll
View at Miami Tattoo Supplies: Clip Cord Sleeves + Machine Bags - Cut-to-Length Roll
Dynarex
Dynarex Patient Dental Bibs - Black
View at Miami Tattoo Supplies: Dynarex Patient Dental Bibs - Black
Hive Cups - Rinse Cups and Cartridge Holder Lids
View at Miami Tattoo Supplies: Hive Cups - Rinse Cups and Cartridge Holder Lids
Ink Caps (#16) Large For Tattoo Ink-Cups
View at Miami Tattoo Supplies: Ink Caps (#16) Large For Tattoo Ink-Cups
CaviCide Surface Disinfectant Wipes 160 Count
View at Miami Tattoo Supplies: CaviCide Surface Disinfectant Wipes 160 Count
Frequently asked questions
What order do you set up a tattoo station in?
Wash hands, disinfect surfaces, glove up, barrier the touch points, cover the tray and armrest, bag the machine and cord, set out ink caps and consumables, pour ink, and open sterile cartridges last. Working from clean to dirty keeps your barriers from being contaminated during setup.
Do you have to bag a tattoo machine?
In Florida, the rule requires barrier covers on equipment that may contact the artist or client, and an artist who skips the machine barrier must disinfect the machine afterwards. The same rule requires the machine and work area to be disinfected with a USEPA-registered tuberculocidal product after every procedure anyway, so bag it and wipe it. Check your own state's rules.
Can you reuse ink caps?
No. Ink is dispensed into clean single-use cups for each client and any unused ink is discarded afterwards. Florida's tattooing rule requires single-use cups for each customer, and pouring leftover ink back into a bottle risks contaminating the whole bottle.
What disinfectant should I use on my tattoo station?
Use an EPA-registered hospital-grade disinfectant and follow the label's contact time. Florida's rule specifies a tuberculocidal disinfectant registered with the USEPA for the machine and work area after each procedure. Wipes such as CaviCide are a common choice; read the label for the wet time.
How long does it take to set up a tattoo station?
It depends on the setup and the artist, and speed is not the goal. A routine you repeat in the same order every time becomes quick naturally. Practice it on every practice-skin session until no step gets skipped.